Ram 100 Installation Specifications - RAMSET RAM 100 Instruction Manual

Hide thumbs Also See for RAM 100:

Instruction manual (31 pages)

Table Of Contents

Table of Contents

RAMSET

WARNING

All Sliding Gate Operators are factory preset

for (LH) Left Hand Installations.

CONCRETE PAD CONSTRUCTION

Dimensions given for the pad are based on soil bear-

ing shear of 2000 P.S.F. These figures may have to

be adjusted depending on local soil conditions.

1. Construct form for mounting pad according to

dimensions shown in Figure 1, 2 and 3.

2. Locate mounting pad according to dimensions

given in illustration.

3. Level top edge of form.

4. Set reinforcing bars and wire mesh.

5. Mix concrete, pour mixture into form. Level and

finish surface after pouring is complete.

6. Allow pad to cure for 48 hours, and remove forms.

Figure 2

concrete

7 1/4"

18"

OPERATOR

C L

GATE