Pushbutton Controls & Master/Slave Installation - RAMSET RAM 100 Instruction Manual

Three pushbuttons are located under the dip switches for operation of the gate (see Figure 15). The opening,
stop and closing buttons can be utilized to set limit switches and verify proper system operation when
installing or servicing an operator.
Opening
Pressing this button will cause the gate to open.
Stop
Pressing this button will cause the gate to
stop moving.
Closing
Pressing this button will cause the gate to close.
Reset E.R.D. Board
Push all three pushbuttons for approximately
5 seconds. All three L.E.D.'s should blink.
Figure 16
MASTER / SLAVE INSTALLATION
(RH) Right Hand operation requires Dip Switch
(C7) "Left/Right" to be ON.
PUShBUTTON CONTROLS
L.E.D.'s light up when Opening,
Closing or Stopped
www.ramsetinc.com
RAMSET
Figure 15
"Intelligate" Control Board
Dip Switch "C"
11