Removal Of Water Valves; Removal Of Thermistor; Removal Of Motor Control Module - Fisher & Paykel Ecosmart GWL15-US-96200 Service Manual

517792A
9.4

Removal of Water Valves

(a) Follow procedures for removal of Display
Module. (Refer to Section 9.2).
(b) Disconnect wiring harness to each coil by
first pulling downwards on the retaining clip.
(c) Remove screw securing the outlet nozzle to
the top deck.
(d) Pull upwards on the spigot to release the
nozzle from the seal in the top deck. As
soon as the seal is broken most of the
residual water will drain from the nozzle.
Remove the water valves from the top deck
ensuring no water comes in contact with
any electrical connections.
Reassembly:
Refit in reverse manner.
9.5

Removal of Thermistor

(a) Follow procedures for removal of Display
Module. (Refer to Section 9.2).
(b) Disconnect thermistor wiring harness to the
Motor Control Module.
(c) Slide body of thermistor out from the valve.
Reassembly:
Refit in reverse manner, ensuring when refitting
the thermistor that the thermistor is pushed until
it comes to a stop against the back wall of the
elbow.
9.6

Removal of Motor Control Module

(a) Follow procedures for removal of Display
Module. (Refer to Section 9.2).
(b) Disconnect all wiring harnesses to the
Motor Control Module.
(c) Remove the pressure tube by squeezing on
the legs of the spring clip. Pull gently on
the tube to slide it off the spigot. Note: If
too much force is used on removal or
reinsertion, damage to the pressure
transducer may occur.
(d) Pull the tab on the top deck harness clamp
towards the front to release the Motor
Control Module.
(e) Lift the Motor Control Module upwards at
the front and out.
Reassembly:
Refit in reverse manner. Important: When refitting pressure tube to pressure transducer ensure
that the pressure tube is clear of any water droplets before operating the machine on a fill cycle. If
the basket is full of water, drain the water then blow down the tube.
Thermistor
42
Pull tab