Wash Motor; Pump Motor; Water Valves; Thermistor - Fisher & Paykel AQUASMART WL26CW1 Service Supplement Manual

Phase 7 hi-efficiency washer
Table of Contents

Advertisement

517794B
1.6

Wash Motor

Electronically commutated 36 pole direct drive 3 Phase brushless DC Motor.
Motor Resistance per Phase 16Ω +/- 10% @ 68
1.7

Pump Motor

The motor is a fully electronically controlled 325V, 3 phase, 6 pole, brushless DC motor.
The speed of the motor will vary depending on whether it is draining or recirculating the water.
Motor Resistance per Phase: 8.1Ω +/- 10% (16.2Ω +/- 10% across any two phases).
Maximum Wattage:
Nominal Wattage:
Drain Speed:
Recirculation Speed:
Head Height
4ft (Nominal)
2500rpm
8ft (Maximum)
2500rpm
1.8

Water Valves

Supply
Mode of
Operation
Cold
Digitally Operated
Hot
Digitally Operated
Detergent
Digitally Operated
Fabric
Digitally Operated
Note: Flow rate will vary slightly depending on pressure.
Water Supply
For best operating conditions your hot water should be approximately 149˚F. The hot water
should not exceed 167˚F or the cold water exceed 95˚F. Temperatures above these may
cause the machine to fault or cause damage to the machine.
If there is an uncontrolled water-heating source (eg a wet back or solar heating) a tempering
device should be fitted. This will ensure the hot water temperature remains within safe limits.
For the most suitable type of tempering device we recommend a local plumber or plumbing
supply merchant be contacted.
Inlet Water Static Pressure 3psi (20kPa) to 150psi (1MPa).
Note: If using a header tank, then the top of the header tank must be at least 2 metres above
the top of the clothes washer.
Minimum flow rate from the tap supplying the clothes washer should be greater than 1.6
gallons (6 litres) per minute (assumes ½ inch diameter pipes).
Minimum height of taps to clear the top of the machine is 45.25 inches (1150mm).
1.9

Thermistor

NTC-type temperature sensor (Thermistor)
1.10

Cabinet

Pre-painted steel
1.11

Lid

ABS plastic (co-injected)
200W
60W
2500rpm
2000 rpm
Drain Speed
6.2 gallons (23.6 litres) per minute
3.9 gallons (15 litres) per minute
Voltage
24V DC
24VDC
24VDC
24VDC
o
o
F (20
C).
Flow Rate
Resistance
o
o
64Ω @ 68
F (20
C)
o
o
64Ω @ 68
F (20
C)
o
o
64Ω @ 68
F (20
C)
o
o
64Ω @ 68
F (20
C)
Resistance 10,000Ω @ 77
8
Flow Rate
2.6 Gal (10 litres) per min.
max
2.6 Gal (10 litres) per min.
max
2.1 Gal (8 litres) per min.
max
.5 Gal (2 litres) per min. max
o
o
F (25
C)

Advertisement

Table of Contents
loading

Table of Contents