Table of Contents
Advertisement
Controls and Features
Front Side / Top Surface / Right Side
9
8
7
6
1 Exhaust vents
Vents for cooling fans through which warm air comes out.
CAUTION
• Do not block the exhaust vents, or heat will build up inside,
possibly causing a fire. Also, do not touch the vents, or this
could give you a low-temperature burn.
2 Carrying handle
Raise this handle when carrying the projector.
CAUTIONS
• When carrying the projector, do not transmit shocks to it.
Also be careful to keep it balanced.
• Do not carry it while the light-source lamp is on or the
cooling fan is operating. This could cause personal injury.
3 AC IN (power input) terminal
This is the power input terminal where the supplied
power cord is connected. For details, refer to page 30.
4 Fuse holder
A fuse rated 15A/250V is installed. (Power source
protection)
To replace the fuse, refer to page 55.
CAUTION
• When replacing the fuse, use the same rating and type.
Otherwise, a fire may occur and/or the projector may be
damaged.
5 MAIN POWER switch
This is the main power switch. When it is turned on, the
projector goes into stand-by state, and the STAND BY
indicator on the control panel comes on. (Refer to
page 31.)
ON [ ]:
The main power turns on.
OFF [ ]:
The main power turns off.
6
1
5 4 3 2
6 Adjustable feet (for adjusting the height and
angle)
By extending the feet, the projector angle can be
adjusted up to +7°.
For details, refer to "Adjusting the Inclination of the
Projector" on page 16.
7 Lens
One of the optional lens units should be installed before
using the projector.
A lens-hole blind cover (black one) is installed when the
projector is shipped from the factory.
For details on the types of optional lenses available, refer
to page 18.
CAUTION
• Please consult your authorized dealer or service center for
information about attaching an optional lens.
8 Lens cap
This is the lens cap provided for the optional lens.
When you are not using the projector, attach the lens cap
to protect the lens from dirt or being damaged. (Refer to
page 30.)
9 Remote sensor
When operating with the remote control, aim it toward
this sensor. (Refer to page 20.)
Left-hand Side / Rear Side
r
p Lens shift knob cap
When you have mounted a lens that uses the lens shift
function, open this cap and rotate the lens shift knob to
move the lens position. For more information, refer to
"Setting the Amount of Lens Shifting" on page 19.
q Speaker
This is the location of the built-in speaker.
w Connector panel
For details, refer to "Connector Panel" on page 11.
e Rear adjustable foot (for leveling the projector)
It is set at the shortest position when shipped from the
factory. Turn the foot to make the projector level.
Adjustment can be made in the range of +1.5° and –1.5°
from the horizontal position. For details, refer to
"Adjusting the Inclination of the Projector" on page 16.
r Air inlet
This is the air inlet. Do not cover or obstruct this slot.
t Control panel
For details, refer to "Control Panel on the Projector" on
page 9.
Controls and Features
t
p
q
w
e
7
Advertisement
Table of Contents
Troubleshooting
