Advertisement
r
A part of image can be magnified up to four times on the
screen.
Each time the T or W button is pressed, the image is
enlarged or the enlarged image is reduced by a certain
degree. (Refer to page 36.)
t
Use these buttons to select a device connected to the PC
1 or PC 2 terminals. (Refer to page 32.)
y
Changes the projection screen size to [4:3] or [16:9].
u
Use this button to automatically align "Brightness",
"Contrast", "Horizontal and vertical position", "Tracking"
and "Phase" for the projected image.
During the automatic alignment, "Quick Alignment"
appears on the screen, and disappears after alignment is
finished. (Refer to page 35.)
• Automatic alignment with the quick alignment function
should be carried out on a bright still-picture. This function
may not work correctly on a dark picture or motion-picture.
If adjustment with this function is not satisfactory, adjust
"Brightness", "Contrast", "Horizontal and vertical position",
"Tracking" and "Phase" in the menu mode.
1
Open the back cover in the direction of the arrow.
2
Place the two supplied batteries (AA/R6-size) in the
remote control as illustrated below.
3
First fit the claws on the back cover in the case, then
close the back cover in the direction of the arrow.
• Do not mix new and old batteries.
• Do not mix different types of batteries as they differ in
characteristics.
• Place batteries so they match the polarities indicated:
(+) to (+) and (–) to (–).
• Be sure to put the minus (–) end in first to avoid
short-circuiting.
• Use only designated batteries.
• Remove the batteries if the remote is not to be used for a
prolonged period.
• When the batteries are exhausted, replace them
immediately. Otherwise, liquid could leak, or malfunction
could occur due to leaking liquid. If the leaked liquid
contacts the skin, wipe it off with a cloth, otherwise the skin
could become rough.
• Do not put batteries into a fire or try to recharge them.
• Batteries run for six months to one year in normal use.
However, the batteries supplied are for confirming
operation and may not run that long. When the remote
control starts failing to work properly, replace the batteries
with new ones.
This instruction below applies only to the use in Holland.
Advertisement
