Advertisement
I
I
RM-M150 REMOTE CONTROL UNIT
The following describes the basic procedure for normal use
of the projector.
1
❙ ❙ ❙ ❙ :The main power turns on and the STAND BY
indicator comes on.
2
• The OPERATE indicator lights and the projected
screen slowly appears.
• After the power is turned on, the image may be jumbled for
a few seconds, but this is not a malfunction.
• After the indicator comes on, it can take a minute or so for
the lamp to warm up and operate consistently.
I
1
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode. The cool-down
mode will continue for approximately 120 seconds.
• The OPERATE button will not work for approximately 1
minute from when the light-source lamp is turned on. Use
the button after approximately 1 minute.
2
‡ ‡ ‡ ‡ :The MAIN POWER switch turns off and the
STAND BY indicator goes off.
• Do not turn off the MAIN POWER switch during cool-down
mode (the STAND BY indicator blinking). Turn it off after
the STAND BY indicator becomes on (stand-by mode).
I
I
RM-M150 REMOTE CONTROL UNIT
I
The display languages of the menus, direct buttons
(DIGITAL ZOOM, KEYSTONE, etc) and messages is set to
"ENGLISH" when the projector is bought. The display
language can be selected from the following 6 languages:
"
(Japanese)", "English (English)", "Deutsch
(German)", "Español (Spanish)", "Italiano (Italian)" and
"Français (French)". (Refer to page 45.) However, some
words (VIDEO, NTSC, Quick Alignment, etc) are only
displayed in English.
• Each time you press either button, the selected input
changes as follows. The selected name appears on the top
right of the image on the screen for five seconds. (Called
line display.)
Press VIDEO.
The input mode changes as follows every time the button is
pressed.
VIDEO ↔ Y/C
Press either the "VIDEO" button or "Y/C" button.
VIDEO: The image from the VIDEO input terminal on the
side of the unit is projected.
Y/C:
The image from the Y/C input terminal on the side of
the unit is projected.
Press PC.
The input mode changes as follows every time the button is
pressed.
PC1 ↔ PC2
Press either the "PC1" button or "PC2" button.
PC1: The image from the PC1 input terminal on the side of
the unit is projected.
PC2: The image from the PC2 input terminal on the side of
the unit is projected.
VIDEO
PC 1
Q U I C K A L I G N M E N T
PC 2
Y/C
VIDEO
• When no image signal is input to the selected input
terminal, the message "No image signal is inputted." is
displayed on the screen. (Refer to page 65.)
• When the PC2 input terminal is used, "PC2 (BNC)" must be
selected from the menu options. (Refer to page 53.)
Advertisement
