Advertisement
The following shows the warning messages that can be displayed on the screen. When a warning message is displayed, take
the corrective action described here.
• No device is connected to the
input terminal.
• The terminal is connected but no
signal is output from the
connected device.
P C 1
N o i m a g e s i g n a l i s i n p u t t e d .
• The frequency of the input video
signal is out of range.
• The selected input mode (input
terminal) name is shown in the
first line of the message.
P C 1
Frequency of image signal is out of range.
• Though the frequency of the input
video signal is within the
acceptable range, other items
such as resolution are out of the
projector's specifications.
P C 1
• The selected input mode (input
N o i m a g e s i g n a l i s s h o w n f o r t h i s t y p e .
terminal) name is shown in the
first line of the message.
• When the FREEZE button is
pressed, this message appears
for a few seconds.
• When a button not acceptable is
pressed during freezing, this
message appears for a few
seconds to notify that the image is
being frozen.
• When the FREEZE button is
pressed for the video signals that
cannot be frozen (UXGA, etc.),
this message appears for a few
seconds to notify that the image
cannot be frozen.
• Connect a device to the selected
9, 11,
terminal.
24 ~ 29,
• Operate the connected device
32
and output a signal.
• Input the video signals whose
22, 23,
frequency is within the projector's
67
specifications.
• Input the video signals that
22, 23,
satisfies the projector's
67
specifications.
• To release freezing, press the
12, 36
FREEZE button on the remote
control.
• Freeze function does not work for
12, 36
the inputted video signals.
To use this function, input the
video signals that can be frozen.
• When the DIGITAL ZOOM button
is pressed for the video signals
that cannot be zoomed (UXGA,
etc.), this message appears for a
few seconds to notify that the
image cannot be digitally zoomed.
• The accumulated lamp use time
reaches 900 hours.
• The accumulated lamp use time
reaches 1000 hours.
The word "Warning" blinks.
The message display language corresponds to the menu display language setting. This is set to "English (English)" when the
projector is bought. The display language can be selected from 6 languages. (Refer to page 45.) However, the input mode
(PC1, PC2,Y/C, VIDEO) and button indications (FREEZE, D.ZOOM, EXIT) are only displayed in English irrespective of the
display language setting.
The language settings in the section are explained in "English".
• Digital-zoom function does not
13, 36
work for the inputted video
signals.
To use the this function, input the
video signals that can be digitally
zoomed.
• Press the EXIT button to clear the
10, 12,
massage.
55 ,57
(This display can be cleared with
the MENU button or other
buttons.)
• Arrange for a new light-source
lamp or replace the light-source
lamp a little earlier.
• Replace the light-source lamp
57 ~ 60
and reset the lamp use time.
Advertisement
