Advertisement
r
e
w
q
p
9
8
1
:
When in stand-by mode.
:When in cool-down mode.
This projector has a function to cool down the heated lamp for a
fixed period of time (approx. 120 seconds) after projection is
finished. This feature is referred to as the cool-down mode.
The purpose of the cool-down mode is to prevent inner parts
from being deformed or broken by heat from the heated lamp
as well as to prolong the life of the lamp.
• Do not turn off the MAIN POWER switch while in the cool-
down mode.
• Do not place the projector on its side or stand it upright
while in the cool-down mode; this may block the vents.
2
: When the projector is in operation (projecting).
: When the projector is not in operation (not
projecting).
3
When the projector is in the stand-by mode, press this
button one second or more, and the projector is turned
on, causing the OPERATE indicator to light.
Press it one second or more again, and the projector
goes into the cool-down mode, then stand-by mode.
(Refer to page 31.)
1
2
3
4
5
6
7
Even if you press the OPERATE button, the projector is not
turned on. Wait until the projector enters stand-by mode
(STAND BY indicator stays lit).
4
Use this button to select a device connected to the PC 1
or PC 2 terminals. Each time you press the button, the
selection alternates between PC 1 and PC 2.
5
Use this button to select a device such as a video deck
connected to the AV IN (Y/C or VIDEO) terminal of the
projector. Each time you press the button, the selection
alternates between Y/C and VIDEO.
6
Use this button to enter or exit the menu mode. The main
menu appears or disappears at the screen. For details,
refer to "Basic Menu Operation" on page 42.
7
This button will be used in the menu mode. Use to
display the hierarchical menus. Also use when "ENTER"
is displayed against the item on the menu screen or
when the "All reset" selection is confirmed. For details,
refer to "Basic Menu Operation" on page 42.
8
5 ∞ 2 3
These buttons will be used in the menu mode to select an
item, or to set or adjust the value. For details, refer to
"Basic Menu Operation" on page 42.
9
This button will be used in the menu mode to return to the
previous menu. When the main menu is displayed, this
button will cause the menu to disappear. For details, refer
to "Basic Menu Operation" on page 42.
p
This PRESET button only works as a reset button for the
direct button adjustment of the KEYSTONE button of the
control panel and the DIGITAL ZOOM button of the
remote control. When adjusting the keystone or digital
zoom (when the setting is displayed on the screen) the
adjusted value is reset to that which was set when the
projector was shipped from the factory. Of the menu
items, this button only works for the keystone setting
screen.
q
Use these buttons to correct a trapezoidal distortion of
the projected image. (Refer to page 34.)
w
Use this button to turn off the image on the screen
temporarily. Pressing it again restores the image to
resume. (Refer to page 34.)
e
:
After the light-source lamp has been used for
more than approx. 900 hours.
: After the light-source lamp has been used for
more than approx. 1000 hours. Replace the light-
source lamp. Refer to "Replacing the Light-
Source Lamp" on page 57.
r
: The temperature inside the projector has risen
abnormally.
• While the TEMP indicator is blinking (during abnormal
temperature), the power is automatically cut off.
Advertisement
