Advertisement
• Read thoroughly the manual that comes with each device.
I
• Use the supplied Personal computer connection cable and the supplied conversion adapter for Mac.
• Other connections are the same as in the connection example for IBM PC or IBM compatible PCs.
Attach the ferrite core when using the S-video cable or infrared remote sensor extension unit which are sold separately.
However, use a cable that can be wound once.
1
2
Attach the ferrite core about 3 cm from the end of the
cord.
3
• When connecting, connect the terminal which is at the
ferrite core end of the cord to the projector.
After all devices have been finished being connected, connect the supplied power cord. At this time,
Y/C
VIDEO
R
P
/R-Y
R
G
H
Y
B
V
P
/B-Y
B
REMOTE
RS-232C
• When you do not use devices, pull out their power cords
from wall outlets.
• Do not connect the devices with power cords other than
those supplied.
• Do not use mains voltage other than the power voltage
indicated.
• Do not scar, damage, or work on the power cords. Also, do
not put a heavy object on, heat, or stretch the power cords,
otherwise they may be damaged.
• Do not insert or pull out the plugs with a wet hand.
I
• Remove the lens cap.
Be sure to fit lens cap when not in use.
.
1
2
• The power cord for the United Kingdom is only included as
a special accessory when shipped to the United Kingdom. It
is not included when shipped to European continent
countries.
• Since the power requirement of the projector is high, insert
the power plug directly into a wall outlet.
• Use the supplied power cord with the ferrite core only.
• Do not remove the ferrite core from the supplied power
cord; Otherwise, there may be a possibility that a harmful
interference occurs.
Advertisement
