Advertisement
You can get information on the input signal, accumulated used hours of light-source lamp, etc.
1
The main menu appears on the screen.
2
The "Information" will be displayed in the main menu.
Menu
Image adj.
VIDEO
Input
Setting
Switcher
CH.0
Color temp.
Source
NTSC
Options
Language
Lamp time
123 h
Information
Input:
Shows the terminal name selected by the VIDEO or PC button. (Y/C or VIDEO, or PC1 or PC2)
Switcher:
This display currently has no meaning. This is reserved for future use. ("CH.0" is usually displayed to
indicate that it is not being used.)
Source:
Shows the projected image's type of video signal. (Video menu mode)
Resolution:
Shows the resolution of the video signal being received. (PC menu mode)
It may not be displayed correctly with some input signals.
Frequency H:
Shows the horizontal frequency of the video signal being received. (PC menu mode)
Frequency V:
Shows the vertical frequency of the video signal being received. (PC menu mode)
Lamp time:
Accumulated used hours of the light-source lamp.
3
5 5 5 5
∞ ∞ ∞ ∞
Menu
Image adj.
PC 1
Input
Setting
Switcher
CH.0
Color temp.
Resolution
1280
1024
Frequency H
79.9
kHz
Options
Frequency V
75
Hz
Language
Lamp time
123
h
Information
A fuse is used to protect the power source of the projector. If the fuse is blown, replace it. When the power switch is turned on
but no power is supplied to the projector, check the fuse. If there are any unclear points, contact the dealer where you
purchased your projector, or consult the Service center.
• When replacing the fuse, use the same rating and type (T6.3A H 250 V). Otherwise, a fire may occur and/or the projector
may be damaged.
1
In stand-by state (the STAND BY indicator lights on),
place the MAIN POWER switch of OFF [ ] position.
2
To loosen the fuse holder, use a Flat-end screwdriver.
3
4
5
To reinstall the fuse holder, use a Flat-end screwdriver.
Advertisement
