Table of Contents
Advertisement
Industry Canada
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation.
The term "IC: " before the certification/registration number only signifies that the Industry
Canada technical specifications were met.
The Ringer Equivalence Number (REN) for this terminal equipment is 0.0B. The REN is an
indication of the maximum number of devices allowed to be connected to a telephone
interface. The termination on an interface may consist of any combination of devices
subject only to the requirement that the sum of the RENs of all the devices does not
exceed five.
This equipment meets the applicable Industry Canada Terminal Equipment & Technical
Specifications.
Placing the receiver slightly above the ear may result in better performance for hearing
aids with microphones positioned behind the ear.
Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating positions accepted by the FCC with
the phone transmitting at its highest certified power level in all tested frequency bands,
although the SAR is determined at the highest certified power level, the actual SAR level
of the phone while operating can be well below the maximum value, in general, the closer
you are to a wireless base station antenna, the lower the power output. Before a new
model phone is a available for sale to the public, it must be tested and certified to the FCC
that it does not exceed the exposure limit established by the FCC, Tests for each phone
are performed in positions and locations (e.g. at the ear) as required by the FCC. This
handset has also been tested and meets the FCC RF exposure guidelines. Use of other
accessories may Non-compliance with the above restrictions may result in violation of RF
exposure guidelines.
50
General information
Advertisement
Table of Contents
