Daikin Super Multi Plus E-Series Service Manual page 250

Instruction
Filters
1. Open the front panel.
2. Pull out the air filters.
3. Take off the Titanium Apatite Photodcatalytic
4. Clean or replace each filter.
5. Set the air filter and the Titanium Apatite
Air Filter
1. Wash the air filters with water or clean them
Titanium Apatite Photocatalytic Air-purifying Filter
The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed by washing it with water once
every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
1. Remove dust with a vacuum cleaner and wash lightly with water.
2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning
3. After washing, shake off remaining water and dry in the shade.
4. Since the material is made out of paper, do not wring out the filter when removing
[Replacement]
1. Remove the tabs on the filter frame and replace with a new filter.
238
• Push a little upwards the tab at the center of
each air filter, then pull it down.
Air-Purifying Filter.
• Press the top of the aircleaning filter onto the
tabs (3 at top). Then press the bottom of the
filter up slightly, and press it onto the tabs
(3 at bottom).
• See figure.
Photocatalytic Air-Purifying filter as they
were and close the front panel.
• Press the front panel at both sides and the
center.
with vacuum cleaner.
• If the dust does not come off easily, wash them
with neutral detergent thinned with lukewarm
water, then dry them up in the shade.
• It is recommended to clean the air filters
every two weeks.
agent.
water from it.
• Dispose of the old filter as flammable waste.
SiEN18-622
tabs (3 at top)
tabs (3 at bottom)
System Configuration