Daikin Super Multi Plus E-Series Service Manual page 208

Instruction
Outdoor Unit
19
Indoor Unit
1. Air filter
2. Air-Purifying Filter with photocatalytic
deodorizing function:
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front grille
5. Grille tab
6. INTELLIGENT EYE sensor:
• It detects the movements of people and
automatically switches between normal
operation and energy saving operation.
7. Display
8. Air outlet
9. Flap (horizontal blade)
10. Louvers (vertical blades):
• The louvers are inside of the air outlet.
11. Operation lamp (green)
12. TIMER lamp (yellow)
13. HOME LEAVE lamp (red):
• Lights up when you use HOME LEAVE
Operation.
Outdoor Unit
18. Air inlet: (Back and side)
19. Air outlet
20. Refrigerant piping and inter-unit cable
Appearance of the outdoor unit may differ from some models.
196
18
14. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table:
Mode
FTKS COOL
FTXS AUTO
• This switch is useful when the remote
control is missing.
15. Packaging materials: 50 class only
• If any packaging materials are included,
please remove before operating.
16. Room temperature sensor:
• It senses the air temperature around the
unit.
17. Signal receiver:
• It receives signals from the remote control.
• When the unit receives a signal, you will
hear a short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop..............beeeeep
21. Drain hose
22. Earth terminal:
• It is inside of this cover.
20
21
22
Temperature Air flow
setting rate
22°C AUTO
25°C AUTO
SiEN18-622
System Configuration