Installation And Placement - Nustep T5 User Manual

Installation and Placement

Unpacking and Installation
Unpacking and installation procedures
for fully assembled T5/T5
are documented in the T5/T5
Installation Guidelines. Unpacking
and assembly procedures for partially
assembled T5/T5
document in the T5 Assembly Manual.
The applicable documents are shipped
with each order. Additional copies of
these documents may be downloaded
from the NuStep, Inc. website.
AC Adapter Use
The T5/T5 is self powered and typically
XR
does not require an external power
source. However, to ensure proper
operation, the equipment must be
plugged in with the provided AC adapter
for low work rates (approximately
60 steps per minute or less). The AC
adapter jack is located in the front of the
equipment.
For adapter specifi cations, please refer to
the technical data section of this manual.
6
shipments
XR
Delivery
XR
shipments are
XR
Placement of Equipment
To ensure safe and effective operation
of your NuStep, place on a fl at, stable
surface. Adjust rear leveler feet as
required.
The minimum amount of required free
space around the equipment is 18 inches
for the sides, and 12 inches for the
front and rear. Additional free space is
necessary to accommodate wheelchair
access.