Chapter 4 Symbologies; Introduction; Scanning Sequence Examples; Errors While Scanning - Motorola CS3000 Manual

CHAPTER 4 SYMBOLOGIES

Introduction

This chapter describes symbology features and provides the programming bar codes for selecting these
features for the scanner. Before programming, follow the instructions in
The scanner ships with the settings in
Parameters for all scanner defaults). If the default values suit requirements, programming is not necessary. Set
a feature value by scanning a single bar code or a short bar code sequences. To return all features to default
values, scan Reset on page

Scanning Sequence Examples

In most cases, scan only one bar code to set a parameter value. For example, to transmit bar code data
without the UPC-A check digit, scan the
Check Digit on page
successful parameter entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in sequence. See
the parameter description for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, re-scan the correct parameter.
Table 4-1 on page 4-2
3-4.
Do Not Transmit UPC-A Check Digit
4-13. The scanner issues a fast warble beep and the LED turns green, indicating a
Chapter 1, Getting
(also see Appendix A, Standard Default
bar code under
Started.
Transmit UPC-A