User Interface Definitions; Led Indications - Motorola CS3000 Manual

Out of Range Behavior
If the scanner moves out of range of the host and does not re-pair with the host within the timeout period, it
stores data in a batch file. This batch data must be manually copied to the host. Within this timeout period, the
scanner does not decode and emits four error beeps in response to scan attempts.
When the radio loses connection, the Bluetooth LED stops its slow, consistent blinking and the beeper emits a
short high low beep. The Bluetooth LED blinks at a faster rate for a period of time while the device attempts to
reestablish pairing with the host, and when it returns within range the device repairs. If repairing is
unsuccessful the Bluetooth LED stops blinking.
To manually reestablish paring when the device returns to range, press the Bluetooth LED button. Upon
Bluetooth pairing, the beeper emits a short low high beep and the Bluetooth LED starts its slow, consistent
blinking again.

User Interface Definitions

The scanner uses beeper and LED sequences to indicate various system events.
define these sequences and events.

LED Indications

LED Indications
Table 2-1
Function Performed
Scan attempt
Successful bar code scan
Battery charge status
Delete bar code
(when in batch mode)
Successful bar code deletion
Unsuccessful deletion - item
doesn't exist (when in batch
mode)
Clear all bar code data
(when delete (-) button enabled)
Successful clear all
User Action LED Feedback
Press scan (+) Flashing green
button
Solid green
Hold scan (+) Flashing green
button 15 seconds
Flashing amber
Flashing red
Press & hold Flashing amber
delete (-) button
Solid amber
Solid red
Press & hold Flashing amber
delete (-) button 3
seconds past scan
time
Solid amber
Scanning
Table 2-1 and Table 2-2
Other
Laser on
Laser off
Full charge (for 8 hours at 6
scans per minute)
Less than 8 hours but more
then one of operating time
Less than 1 hour of operating
time
Laser on
Laser off
Laser off
Laser on
Laser off
2 - 3