Table of Contents
Advertisement
20
mymail Operator Manual
4.2
Positioning and franking a letter
If all the settings for the franking imprint are correct, you can position and frank the
letter.
Caution! Never lift up the operating panel during franking. Opening the flap
causes the mymail to abort printing immediately for safety reasons. Franking
may be incomplete and useless.
You can frank letters up to a thickness of 6 mm.
For thicker letters, frank the empty envelope or use the special FP double
labels (franking labels).
Use envelopes made of ink-absorbent material with as smooth a surface as
possible. This gives the best printing results.
The main menu must be visible in the
display for franking.
Position the letter
– side to be printed face up
– top edge first.
Place a letter at the right hand edge of the
letter slot and push in as far as it goes.
As soon as the sensor (in the back right
hand corner of the letter slot) detects the
letter, the mymail grips the letter tightly
and prints (franks) it after a short time.
"Please wait ..." appears in the display
during franking. Do not remove the letter
until the main menu reappears and the
mymail releases the letter.
Advertisement
Table of Contents
