Electrolux ICON E24CM75GSS Technical & Service Manual page 61

L L o o w w P P r r e e s s s s u u r r e e F F l l o o w w M M e e t t e e r r R R e e m m o o v v a a l l
The low pressure flow meter is located to the right of
water tank when looking at unit from the rear.
To remove low pressure flow meter (See Figure 4-40):
1. Pull unit out from installation and remove from the
installation cavity.
2. Remove top stainless steel cover assembly.
3. Remove rear panel.
4. Disconnect wire leads from low pressure flow
meter.
5. Remove water lines from low pressure flow meter.
M M a a g g n n e e t t i i c c S S e e n n s s o o r r R R e e m m o o v v a a l l
The magnetic sensor is mounted to the base of the
water tank mounting bracket with two nuts.
To remove the magnetic sensor (See Figure 4-41):
1. Pull unit out from installation and remove from the
installation cavity.
2. Remove top stainless steel cover assembly.
3. Remove rear panel and water tank.
4. Disconnect wire leads from magnetic sensor. The
disconnects are located behind the water tank
mounting bracket and next to boiler assembly.
5. Using two 13mm wrenches, remove top nut from
sensor then pull out from unit.
6. After installing the new magnetic sensor, completely
fill water tank with filtered water and test with an
ohmmeter. With the water tank full the magnetic
sensor should test as a closed switch. Remove
water from tank and check again, the sensor should
test as an open switch.
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
F F i i g g u u r r e e 4 4 - - 4 4 0 0 . . L L o o w w P P r r e e s s s s u u r r e e F F l l o o w w M M e e t t e e r r
Magnetic
Sensor
13mm
Nuts
F F i i g g u u r r e e 4 4 - - 4 4 1 1 . . M M a a g g n n e e t t i i c c S S e e n n s s o o r r R R e e m m o o v v a a l l
4-19
Electrical
Connection
Water Lines
To Wire
Harness
Electrical
Connection