Electrolux ICON E24CM75GSS Technical & Service Manual page 59

G G r r i i n n d d e e r r A A s s s s e e m m b b l l y y B B r r e e a a k k d d o o w w n n
To remove the components of the grinder assembly
(See Figure 4-36):
1. Follow steps 1-6 above.
2. Turn the blade support counterclockwise and
remove from grinder assembly.
3. Using a flat-bladed screwdriver, extract screws
securing the top grinder blade to underside of the
blade support.
4. Extract screws securing the lower grinder blade to
the top of lower blade support.
5. Using an 11mm socket, extract the left hand thread
brass nut from lower blade support. A small tool,
such as a flat-bladed screwdriver will be needed to
stop the motor shaft from turning while extracting
the brass nut. Slide the lower blade support off
motor shaft.
6. Using a 2.5mm allen head wrench extract screw
securing the coffee slide to grinder assembly.
7. Using a phillips head screwdriver, extract the
screws securing grinder motor to grinder mounting
bracket.
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
Blade Support
O-ring
Grinder Blade
Brass Nut
Screw
Coffee
Slide
Grinder Motor
F F i i g g u u r r e e 4 4 - - 3 3 6 6 . . G G r r i i n n d d e e r r A A s s s s e e m m b b l l y y B B r r e e a a k k d d o o w w n n
4-17
Screws
3 per
Grinder
Blade
Lower
Blade
Support
Mounting
Bracket
Screws