Electrolux ICON E24CM75GSS Technical & Service Manual page 62

C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
W W a a t t e e r r P P u u m m p p A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
The water pump assembly is located directly beneath
water tank and is secured to base plate with screws.
Water lines attached to the pump are secured with
tie-down straps or compression fittings.
To remove water pump assembly (See Figure 4-42):
1. Pull unit out from installation and remove from the
installation cavity.
2. Remove top stainless steel cover assembly.
3. Remove rear panel.
4. Disconnect wire leads from water pump motor
terminals.
5. Slide coffee maker off edge of table or countertop
to access the screws from the underside of the
base plate. Then, using a 2.5mm allen wrench and
a 7mm wrench, extract the screws securing the
water pump assembly to base plate.
6. Use a wire cutters to remove the tie-down straps
securing water lines to water pump assembly.
Compression fittings require a 12mm open end
wrench to be removed from the water pump.
2 2 - - W W a a y y S S o o l l e e n n o o i i d d R R e e m m o o v v a a l l
The 2-way solenoids are mounted to a bracket along
the right side of inner frame next to the boiler assem-
bly. Allen head screws secure the 2-way solenoids to
the mounting bracket.
To remove the 2-way solenoids (See Figure 4-43):
1. Pull unit out from installation and remove from the
installation cavity.
2. Open door and remove drip tray and coffee
grounds drawer from unit. Remove door assembly.
3. Remove top stainless steel cover assembly and left
side cover panels.
4. Disconnect wire leads from solenoid terminals.
5. Using a 12mm open end wrench, remove water line
fittings from solenoid.
6. From opposite side of mounting bracket, use a
2.5mm allen wrench and extract screws securing
the solenoid to mounting bracket.
Tie-down Straps
Electrical Connections
F F i i g g u u r r e e 4 4 - - 4 4 2 2 . . W W a a t t e e r r P P u u m m p p A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
Screws
F F i i g g u u r r e e 4 4 - - 4 4 3 3 . . 2 2 - - W W a a y y S S o o l l e e n n o o i i d d R R e e m m o o v v a a l l
4-20
12mm Nuts
Compression Fitting
Water Line
Fitting
Solenoid
Compression
Compression
2-Way
Fitting
2-Way
Solenoid
Fitting