Download  Print this page

Electrolux ICON E24CM75GSS Installation Instructions Manual

Built-in coffee maker
Hide thumbs


Electrolux I ic o N
102221 REV. C -2


Table of Contents

  Summary of Contents for Electrolux ICON E24CM75GSS

  • Page 1 Installation Instructions Built-In Coffee Maker Electrolux I ic o N E24CM75GSS E24CM76GSS 102221 REV. C -2...
  • Page 2: Before You Begin

    For toll-free telephone support in the U.S. and Canada. INTERNET For online support and product information: In the U.S. visit In Canada, visit © 2007 Electrolux Home Products, lnc, Post Office Box 212378, Augusta, Georgia 30917, All rights reserved.
  • Page 3: Table Of Contents

    Finding Information TABLE OF CONTENTS Installation ............... Before You Begin ............2 Before You Start ........10 Finding Information ..........3 Tools Needed for Installation ...11 Important Safety Instructions ... 4 Plumbing Installation ......1 2 Installing the Cabinet Glides .... 14 Safety ................
  • Page 4: Important Safety Instructions

    /_WARNING Electrolux cannot be held responsible for damage to property or injury to persons caused by failure to comply with the installation, maintenance and safety instructions contained in this handbook...
  • Page 5: Safety

    Safety ,,&WARNING To reduce the risk of fire, electrical shock, or injury when using your coffee maker, follow basic safety precautions including the following: Read all instructions before operating the coffee maker. IMPORTANT: Before performing any type of service or installation, make sure that electric power to the coffee...
  • Page 6 Safety General Safety Precautions (continued) ,'&WARNING Do not tamper with the controls. Clean the coffee maker thoroughly according to the Flushing Out the Coffee Maker section in the use and care guide before operating it for the first time. • When installing or cleaning...
  • Page 7: Preparing For Installation

    Preparing for Installation PLANNING THE LOCATION 4" X 12" (100ram - 300ram) Ventilation Cut-Out in Cabinet Back 24" _lomm) 22 1/8"- 22 3/8" Steam Barner (582mm - 588mm) 3/4" (19ram) Min Side Walls 20 3/4" 527mm ) 3/4" 19mm) Level Support Platform _ 1/8"...
  • Page 8 The user needs to be able to pour coffee into the coffee bins on top and, on model E24CM75GSS, be able to remove the water tank for filling and cleaning. Install the coffee maker low enough so that the user can reach the top of the unit easily when it is slid out of the cabinet.
  • Page 9 Power Cord Length 60 inches Unit Weight 110 Ibs. Shipping Weight 139 Ibs. Fresh Water Capacity 5 Liters/1.3 Gallons (Model E24CM75GSS) Minimum Input Water Pressure 1.40 Bar (20 psi) (Model E24CM76GSS) Maximum Input Water Pressure 2.75 Bar (40 psi) (Model E24CM76GSS)
  • Page 10: You Start

    1116" (lmm) Three foot 114" to 314" flexible water supply hose(E24CM76GSS) Use & care guide Detergent tablets (sample) Spare tank O-ring (model E24CM75GSS) Spare piston assembly O-ring Allen wrench (for grinder adjustment) Anti-liming powder (sample) Measuring cup for ground coffee...
  • Page 11: Installation

    Installation TOOLS NEEDED FOR INSTALLATION • Phillips screwdriver • Measuring tape • Level • Drill with 1/16" drill bit STEAM BARRIERINSTALLATION Position the steam barrier inside the top of the cut-out. Push it towards back wall until the back edge lines up with the back...
  • Page 12: Plumbing Installation

    For Model E24CM75GSS (Tank Model): • If the water hardness level is above four grains per gallon (4 gpg) you must use filtered water with a hardness of 4 gpg or less. Do not use distilled water.
  • Page 13 Installation To house water supply To coffee maker Filter head Everpure Filter Cartridge Electrolux ACCFILT-24 Filter Kit with Filter Installed...
  • Page 14: Installing The Cabinet Glides

    Installation INSTALLING THE CABINET GLIDES The cabinet glides mount inside of the cabinet. The glides on the coffee maker slide into cabinet glides. The guide system allows coffee maker to slide in and out of the cabinet loading coffee bins and for maintenance.
  • Page 15 Installation Put the two (2) cabinet 4" (100mm) glide assemblies, Cabinet Back Cutout for shims if necessary, Circulati on shown on the inside surfaces of the cabinet. Position them 3 1/2" (9.0cm) from the front edge of the cutout opening. Insert the screws the holes of the glides 3 1/2"...
  • Page 16: Glides

    Installation INSTALLING THE UNIT IN THE CABINET V'_ile supporting the coffee maker from below, insert it into the cabinet cutout. As you insert it into the cabinet, line up the glides on the appliance with the cabinet glides. The appliance should glide on the rails when slight pressure is applied to the front of the coffee maker.
  • Page 17: Plumbing

    Installation CONNECTING THE PLUMBING (E24CM76GSS) Z WARNING • To prevent damage to the coffee system due to hard water, prior to installation, check the water hardness for the building where you will be installing the coffee maker. See page 12 •...
  • Page 18: Verifying Operation

    On model E24CM76GSS (plumbed model): Turn on the water supply at the shut-off valve. Check the water lines for leaks. On model E24CM75GSS (tank model): Fill the tank with filtered water (4 gpg maximum water hardness, do not use distilled water).
  • Page 19 Repeat the verification process. If the appliance still does not work, contact an authorized Electrolux at the phone number inside the front cover. INSTALLATION CHECKLIST AkWARNING To ensure a safe and proper installation,...
  • Page 20 Electrolux_ 1 - 877 - 4 Electrol www.electrol

This manual is also suitable for:

Icon e24cm76gss