Electrolux ICON E24CM75GSS Technical & Service Manual page 39

P P r r o o b b l l e e m m
Amount of coffee made is too small.
Coffee maker will not make coffee
drinks from ground coffee.
Display reads: "Please Wait Heating"
Display reads: "Drawer Full" (buttons
also don't work).
Display reads: "Machine Ready -
Drawer Out" (buttons also don't work).
Display reads: "System Off - Front
Panel Open" (buttons also don't work).
Display reads: "Clean Group"
Display reads: "Xxxxxx Group Error"
(buttons also don't work).
Display reads: "Timeout Filling Up
Broiler" (buttons also don't work).
Display reads: "Flow Meter Error"
(buttons also don't work).
Display reads: "Error - Coffee
Temperature" or "Error - Steam
Temperature" (buttons don't work).
Display reads: "Too Much Coffee".
Used coffee beans in used coffee
grounds bin are not normal shape.
Coffee beans in bin normally look like
little "hockey pucks".
1. Normal size of a cup of espresso is about one ounce. Push espres-
so or double espresso button multiple times.
1. Put pre-ground coffee in ground coffee chute before the power
switch is turned on.
1. Appliance still heating up. Wait until display reads "Machine Ready"
(3-5 minutes).
1. Empty used coffee grounds bin. See Cleaning the Coffee Maker.
Drawer was emptied with power switch off. Leave power switch on
when emptying the used coffee grounds bin.
1. Check to make sure used coffee grounds drawer is properly
installed. See Cleaning the Coffee Maker.
1. Check to make sure front panel is closed and locked.
2. Check Microswitch. Replace if defective
1. System needs a routine cleaning. See Cleaning the Coffee Maker.
"Clean Group" message will disappear after the routine cleaning is
complete.
1. Operation problem detected. Open and close front panel.
2. Check Control Panel, replace if defective.
1. Operation problem detected. Turn power switch off, then on.
2. Check boiler Water Level Sensor, replace if defective.
1. Pour water in tank (Model E24CM75GSS) or check to make sure
the water supply is connected and turned on Model
(E24CM76GSS).
2. Check Flow meter, replace if defective.
1. Operation problem detected.
2. Check Thermostat and Temperature Sensor on boiler. Replace if
defective.
1. Reduce the amount of coffee put in the ground coffee chute.
2. Grind time programmed incorrectly. Change the grind time to the
default setting. See Original Factory Programmed Settings.
1. Change group program setting.
3-3
T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
P P o o s s s s i i b b l l e e S S o o l l u u t t i i o o n n