Samsung OfficeServ ITP-5121D User Manual page 258

SYSTEM TONES
The system provides several tones to assist you. Some of these tones are already
familiar to you.
Intercom Dial Tone—A steady tone that indicates you can begin dialing.
DIAL TONE
Ringback Tone—Indicates the station you dialed is ringing.
RINGBACK TONE—1000 ms ON/3000 ms OFF
Busy Tone—Indicates the station you dialed is busy.
BUSY TONE—500 ms ON/500 ms OFF
DND/No More Calls Tone—Fast busy tone indicates the station you dialed
is in the Do Not Disturb mode or cannot receive any more calls.
DND/NO MORE CALLS TONE—250 ms ON/250 ms OFF
Transfer/Conference Tone—Indicates your call is being held and you
can dial another party.
TRANSFER/CONF TONE—100 ms ON/100 ms OFF
Confirmation Tone—Very short beeps followed by dial tone indicate you
have correctly set or canceled a system feature.
CONFIRMATION TONE—50 ms ON/50 ms OFF
Error Tone—A distinctive two level beeping tone indicates you have done
something incorrectly.Try again.
ERROR TONE—50 ms of tone 1/50 ms of tone 2
CONTINUOUS
CONTINUOUS
CONTINUOUS
FOR TEN SECONDS
CONTINUOUS
FOR ONE SECOND
(programmable)
FOR THREE SECONDS
3
Home Page
OUTSIDE CALLS
MAKING AN OUTSIDE CALL
• Lift the handset and receive internal dial tone.
• Dial a C.O. line or line group access code.
• Receive outside dial tone and then dial the telephone number.
• Finish the call by replacing the handset.
If your system is programmed to require an authorization code before making a
call:
Dial , and a valid code. You will hear confirmation tone, followed by dial
•
tone.
• Select a C.O. line.
If your system is programmed to require an account code before making a call:
• Dial 47 and a valid code.
• Hookflash and receive transfer tone. Select a C.O. line.
For more information see your system administrator.
ANSWERING AN OUTSIDE CALL
• Lift the handset. You are automatically connected to the ringing call.
• Finish the call by replacing the handset.
UNIVERSAL ANSWER
Outside lines may be programmed to ring a general alerting device. To answer
calls ringing this device, dial 67. This device can operate in any system ring mode.
SENDING A FLASH
While you are on an outside call, hookflash, receive transfer tone and dial 49 to
send a flash to the telephone company. This may be required for some custom call-
ing features or CENTREX lines.
Note: Flash is not available on an ISDN circuit.
4
Table of Contents STD Telephone