Set Camshaft Position; Tighten Camshaft Front Sprocket; Disconnect Cold Start Device - Volvo D 20 Service Manual

Group 2l Engine
Basic setting
C7
Set camshaft position
Place gaLrge 5190 at rear of camshaft. Insert a 0.2 mm
(0.008 in) ieeler sause beneath lefi side of sause to
compensate for timing gear clear;nce.
Camshafi;s now set at correct position.
C8
Make sure cyl. no. 1 is
Check 0 mark on flywheel
at top dead center
and adiust if necessary.
C9
Tighten camshaft front sprocket
Use 5199 to prevent sprocket from turning. Make sure
that camshaft does not turn.
Torque center bolt to 4s Nm (33 ft lbs).
c 1 0
Remove gauge 5190 and leeler gauge
c l 1
Disconnect cold start device
Slacken screw 1. Push lever forward and rotate sleeve
90". Notel Do not turn screw 2 otherwise it will be
necessary to remove cold start device and reset it on a
)r