Air Flow Selection - Daikin D-Series Service Manual

Instruction

Air flow selection

• Make air flow selection according to what suits you.
When setting the air flow selection switch to
• Air conditioner automatically decides the appropriate blowing pattern depending on the operating
mode/situation.
Operating mode
COOL mode
HEAT mode
• During Dry mode, so that cold air does not come into direct contact with people, air is blown upper air outlet.
When setting the air outlet selection switch to
• Regardless of the operating mode or situation, air blows from the upper air outlet.
• Use this switch when you do not want air coming out of the lower air outlet. (While sleeping etc..)
CAUTION
• Do not try to adjust the flap by hand.
• When adjusting by hand, the mechanism may not operate properly or condensation may drip from
air outlets.
154
Situation
• When the room has become fully
cool, or when one hour has passed
since turning on the air conditioner.
• At start of operation or other times
when the room is not fully cooled.
• At times other than below.
(Normal time.)
• At start or when air temperature is
low.
.
Blowing pattern
• So that air does not come into direct
contact with people, air is blown
upper air outlet, room temperature is
equlised.
• Air is blown from the upper and lower
air outlets for high speed cooling dur-
ing COOL mode, and for filling the
room with warm air during HEAT
mode.
• So that air does not come into direct
contact with people. Air is blown
upper air outlet.
.
Si12-619A
Operation Manual