Setting The Receiving Channel; Selecting The Group/Channel; Using The Active Channel Scan Function - Sony DWR-R01D Operating Instructions Manual

Setting the Receiving
Channel
The receiver provides groups of channels for interference-
free transmission. When using multiple wireless
microphones and transmitters (simultaneous multi-
channel operations) within the same area, selecting the
same group and using a channel within that group can
prevent signal interference.
For details on groups and channels, refer to "Sony Digital
Wireless Microphone System Frequency Lists" on the
supplied CD-ROM "Digital Wireless Receiver."
For details on menu operations, see "Basic Menu
Operations" on page 26.

Selecting the Group/Channel

Set the group (GP) and channel (CH) as follows:
In the procedure below, the controls for the receiver
channel 1 are used for illustration purposes.
1
Press the RECEIVER button to select the RECEIVER
menu.
2
Rotate the jog dial to move the cursor to GP/CH
indication (the characters of the item selected with the
cursor become highlighted), and then press the dial.
3
Rotate the jog dial to move the cursor to group
indication that you want to select, and then press the
dial.
4
Rotate the jog dial to move the cursor to channel
indication that you want to select, and then press the
dial.
When the wireless remote control function (see
page 28) is operating:
When you change the channel setting on the receiver, the
new channel setting is sent to the transmitter that is paired
with that receiver.
About operation when using with
dedicated digital channel plan
When performing multi-channel operation with a channel
plan for digital only, make sure the RF indicator is always
lit in green when in the operation area. The RF indicator
lights in red or goes out when the reception signal input is
weak, and lights in orange when it is strong.
If necessary, we recommend adjusting the gain of the
connected antenna and configuring settings such as the
antenna attenuator and antenna direction.
About use of the same group and channel
by adjacent systems
When the same group and channel are being used by two
or more systems that are within sight of each other and are
separated without partitions or obstacles in wide open
place, each system should be at least 100 meters away
from the others to avoid interference.
Using the Active Channel Scan
Function
This function scans for a Sony digital wireless frequency
from the channel lists within the GP (group) selected
during the GP/CH selection function.
Required condition for the detection:
• Sony digital wireless signal
• The setting of the encrypted transmission function is
correct.
1
Press the RECEIVER button to select the RECEIVER
menu.
2
Rotate the jog dial to move the cursor to ACTIVE CH
SCAN indication, and then press the dial.
A message "START SCAN?" appears.
3
Rotate the jog dial to select YES, and then press the
dial.
Scanning starts. When a Sony digital wireless
frequency is detected, scanning stops and the
frequency is displayed.
If you select NO in this step
The scanning function is cancelled.
4
If you decide to use that channel, rotate the jog dial to
select SET, and then press the dial.
To search for another frequency
Rotate the jog dial to select CONTINUE, and then
press the dial.

Setting the Receiving Channel

23