Sony DWR-R01D Operating Instructions Manual page 11

1 Display
The contents of the display before the DWR-R01D enters menu operation (top display) are described below. Since the top
display shows information contained in the metadata sent from the transmitter as well as the receiver settings and status,
this can be used for operation monitoring.
The display contents of receiver channel 1 and 2 are the same. The display of receiver channel 1 is used for illustration
purposes.
1 QL meter
0 RF indicator
qa RF level meters
qs Antenna selection indication
a QL (signal quality level) meter
Indicates the quality of data that is received.
This meter allows you to monitor RF signal deterioration
that may occur when there is signal interference or when
the transmitter is too far from the receiver.
b Receiver channel number
Indicates the receiver channel number.
c Wireless remote control condition indication
Indicates the signal transmission condition of the wireless
remote control function (four levels).
: Good transmission
: Somewhat good transmission
: Somewhat poor transmission
: Poor transmission
: Unable to communicate with paired transmitter
Note
When the wireless remote control function (see page 28) is
off, this indication does not appear.
d Digital output sync indication
Indicates sync status of the signal output from the
DIGITAL OUT connectors.
2 Receiver channel number
9 Reception channel information
INT: Output signal is in sync with the internal clock.
EXT: Output signal is in sync with the signal input from
the WORD SYNC IN connector.
e Audio level meter
Indicates the level of audio signal input to the transmitter.
The segments indicating below the reference input level of
the transmitter appear dimly.
When "MIC" is set for the reference input level on the
transmitter: Segments indicating –36 dBFs or below
appear dimly.
When "LINE" is set for the reference input level on the
transmitter: Segments indicating –20 dBFs or below
appear dimly.
f AF/PEAK (audio signal peak) indicator
Lights up green when the audio signal exceeding reference
level is input to the transmitter.
Lights up red when the audio signal exceeding –3 dBFs is
input to the A/D converter on the transmitter.
g Transmission power indication
Indicates the current transmission power setting. This
setting can be changed in the TRANSMITTER menu (see
page 27).
3 Wireless remote control condition indication
4 Digital output sync indication
5 Audio level meter
6 AF/PEAK indicator
7 Transmission power indication
8 Battery indication
11
Parts Identification