Items Related To Network (Network Submenu); Items Related To Display (Display Submenu); Resetting Parameters To Their Factory Settings (Factory Preset); Displaying The Software Version (Version) - Sony DWR-R01D Operating Instructions Manual

Compensating delay times for receiver channels
1 and 2
The delay times for receiver channels 1 and 2 may be
different when the DWR-R01D is used with two digital
wireless transmitters of differing models. By setting this
compensation function to ON in such cases, you can
automatically adjust the receiver channel with the shorter
audio signal delay time to match the channel with the
longer delay.
When adjusting the delay time manually using a device
such as mixer or delay processor, set this function to OFF.
Items Related to Network
(NETWORK submenu)
Naming the receiver
Enter a receiver name of up to 16 characters in the same
manner described in "Using Password Mode
(PASSWORD)" on page 25.
When the receiver is already named, selecting this item
displays the receiver name.
IP address setting
(IP ADDRESS)
Enter the IP address of the receiver.
Subnet mask setting
Enter the subnet mask for the receiver.
Note
IP addresses and subnet masks
• If you are not using a standard network line connection,
configure the following private address. Configure
values that are unique within the network for the "x"
values.
IP Address: 192.168.0.xxx
Subnet Mask: 255.255.255.0 (fixed length)
• If you are using a standard line connection, consult your
network administrator.
• If IP address settings are changed, pairings with NT
remote systems will be disabled. Be sure to perform the
pairings again.
Items Related to Display (DISPLAY
submenu)
Setting the brightness of the display
(BRIGHTNESS)
Ten levels of brightness can be selected for the organic
light-emitting diode display.
The selectable settings are the following:
(Dark) 1 2 3 4 5 6 7 8 9 10 (Bright)
(RECEIVER NAME)
(SUBNET MASK)
Automatic dimming of the display
MODE)
The organic light-emitting diode display can be set to dim
or turn off after a certain amount of time.
AUTO OFF: The display turns off after 30 seconds. The
display goes on again when you use any button/control.
AUTO DIMMER: The display dims after 30 seconds. The
display becomes bright again when you use any button/
control.
ALWAYS ON: The display stays on at the brightness
level set with the BRIGHTNESS function.
Resetting Parameters to Their
Factory Settings
All parameter settings can be returned to their factory
settings.
A message appears asking for confirmation. Rotate the jog
dial to select YES.
The receiver parameters are reset to their factory settings.
Displaying the Software Version
(VERSION)
The version of receiver software can be displayed.
(DIMMER
(FACTORY PRESET)
UTILITY Menu
31