Table of Contents
Advertisement
Setting the Receiving
Channel
The receiver provides groups of channels for interference-
free transmission. When using multiple wireless
microphones and transmitters (simultaneous multi-
channel operations) within the same area, selecting the
same group and using a channel within that group can
prevent signal interference.
For details on groups and channels, refer to "Sony Digital
Wireless Microphone System Frequency Lists" on the
supplied CD-ROM "Digital Wireless Receiver."
For details on menu operations, see "Basic Menu
Operations" on page 23.
Selecting the Band Block
This receiver is capable of receiving signals in a wide band
of frequencies.
Set the band block before setting the frequency band/
group/channel.
Set the band block (BAND BLOCK) as follows.
The controls for channel 1 are used in the following
illustration for explanation purposes.
1
Press the UTILITY button to select the UTILITY
menu.
2
Rotate the jog dial to move the cursor to the RF
indication (the characters of the item selected with the
cursor become highlighted), and then press the dial.
3
Rotate the jog dial to move the cursor to the BAND
BLOCK indication, and then press the dial.
4
Rotate the jog dial to move the cursor to the band block
indication that you want to select, and then press the
dial.
Selecting the Frequency Band
Set the frequency band before setting the group/channel.
Set the frequency band (BAND) as follows.
The controls for channel 1 are used in the following
illustration for explanation purposes.
1
Press the RECEIVER button to select the RECEIVER
menu.
2
Rotate the jog dial to move the cursor to the BAND
indication, and then press the dial.
3
Rotate the jog dial to move the cursor to the frequency
band indication that you want to select, and then press
the dial.
Selecting the Group/Channel
Set the group (GP) and channel (CH) as follows:
In the procedure below, the controls for the receiver
channel 1 are used for illustration purposes.
1
Press the RECEIVER button to select the RECEIVER
menu.
2
Rotate the jog dial to move the cursor to GP/CH
indication (the characters of the item selected with the
cursor become highlighted), and then press the dial.
3
Rotate the jog dial to move the cursor to group
indication that you want to select, and then press the
dial.
4
Rotate the jog dial to move the cursor to channel
indication that you want to select, and then press the
dial.
19
Advertisement
Table of Contents
