Table of Contents
Advertisement
2
After inserting the receiver completely into slot,
securely fasten the four mounting screws.
Receiver
For details about operating the camcorder with the
receiver, refer to the operating instructions supplied with
the camcorder.
Notes
• Make sure to attach DWA-SLAS1 (sold separately)
when connecting Sony devices.
• When connecting non-Sony devices using
DWA-SLAU1 (sold separately), refer to the attachment
instructions of the applicable device.
• If the camcorder is not compatible with the receiver, the
compatibility pin on the receiver will make it impossible
to insert the receiver into the slot.
For details on compatible camcorders, consult a Sony
sales representative.
Using the DWA-01D/F01D wireless
adapter
Attaching the receiver to the DWA-01D/F01D wireless
adapter allows them to be used as a portable wireless
receiver.
For details, refer to the operating instructions supplied
with the adapter.
Setting the Receiving
Channel
The receiver provides groups of channels for interference-
free transmission. When using multiple wireless
microphones and transmitters (simultaneous multi-
channel operations) within the same area, selecting the
same group and using a channel within that group can
prevent signal interference.
Selecting the band block
This receiver is capable of wide band reception.
Before setting the frequency band, group, or channel, set
the band block.
Use the following procedures to set the band block.
1
Press the MENU SELECT button repeatedly until the
UTILITY menu (meter indication) is displayed.
2
Press the + or – button repeatedly until the BAND
BLOCK indication is displayed.
3
Hold down the SET button until the item to be set
flashes.
4
Press the + or – button repeatedly to select BAND
BLOCK.
5
Press the SET button to enter the setting.
Selecting the frequency band /
group / channel
Set the frequency band (BAND), group (GP), and channel
(CH) as follows.
For details on the groups and channels included in each
frequency band, refer to the frequency lists.
For details on menu operations, see "Basic menu
operations" on page 12.
1
Press the MENU SELECT button repeatedly until the
RX1/RX2 menu is displayed.
7
Advertisement
Table of Contents
