Displaying The Remote Mode (Mode) - Sony DWR-R01D Operating Instructions Manual

4
Rotate the jog dial to select the transmitter to be paired
with from among those indicated, and then press the
dial to enter the setting.
The receiver starts to communicate with the selected
transmitter and the wireless remote control condition
appears in the display. The condition level (indicated
by ) goes up and the remote control function
becomes operative.
On wireless remote control condition indication
Indicates the signal transmission condition of the wireless
remote control function (four levels).
: Good transmission
: Somewhat good transmission
: Somewhat poor transmission
: Poor transmission
: Unable to communicate with paired transmitter
When the wireless remote control function (see page 28) is
off, this indication does not appear.
Using the wireless remote control function
with a previous pairing
If the wireless remote control condition icon is displayed
on the top display of the receiver when the power of the
transmitter is ON, use is possible as is.
If the icon is not displayed, check whether the RF
REMOTE setting of the transmitter or receiver is set to
ON.
Notes
• When you set the wireless remote control function to
ON, the transmitter will communicate with the receiver
to which it was previously paired. To use the RF
REMOTE function with another transmitter, you must
perform the pairing procedure again for that transmitter.
• Pairing with multiple transmitters is not possible.
• Even if pairing was performed in an ST remote system,
pairing needs to be performed again to use the wireless
remote control in an NT remote system.
The following transmitter settings can be
performed when pairing is established:
• Group/channel setting
• RF transmission power setting
• Audio input attenuation setting
Wireless remote control
condition indication
• Low-cut filter setting
• Power save setting
• +48V setting
For details on the transmitter settings, see "Changing the
Settings on the Transmitter" on page 32.
Cancelling the wireless remote control
function
In the RF REMOTE menu, select RF REMOTE, and then
select OFF.
Notes on the wireless remote control
function
The wireless remote control function on the receiver uses
the 2.4 GHz band and may thus be subject to interference
from other devices.
• When pairing fails ("Pairing fail" is displayed), carry out
pairing again. Successful communication between the
transmitter and the receiver has not occurred within a
given amount of time. Pairing may be harder to do when
another receiver is engaged in pairing nearby.
• When it becomes hard to use the remote control, the
remote control may be improved by switching the RF
REMOTE function off, then on again, and then re-
pairing with the transmitter (change to a channel with
less interference).
Displaying the Remote Mode
Display whether the receiver is operating in the ST remote
or NT remote mode. (The mode can only be displayed.)
NT: The receiver has recognized the RMU-01 unit and is
operating in NT remote mode.
ST: The receiver is operating in ST remote mode.
SEARCH: The receiver is searching for the remote mode
state.
(MODE)
29
RF REMOTE Menu