Utility Menu; Items Related To Signal Reception (Rf Submenu); Items Related To Audio (Audio Submenu) - Sony DWR-R01D Operating Instructions Manual

UTILITY Menu

For details on menu operation, see "Basic Menu
Operations" on page 26.
The UTILITY menu includes items related to the basic
receiver settings, including displays.
In this section, the functions included in the menu and their
parameters are explained.
Underlined items are the factory settings.
The following shows the US model display.
Function name
Note
All the items in the UTILITY menu can be set by using the
controls on the receiver channel 1. The UTILITY menu
settings are applied to both receiver channels.
Items Related to Signal Reception
(RF submenu)
Frequency band setting
Selects the frequency band that the transmitter uses.
US models
DWR-R01D/30: TV30-33/TV34-36/TV38-41
DWR-R01D/42: TV42-45/TV46-49/TV50-51
European model
DWR-R01D/62: TV62-64/TV67-69
Antenna attenuator setting
Sets the attenuator for the antenna input.
This item can be set independently for each of the
ANTENNA IN connectors.
0dB/5dB/10dB
Note
When connecting DWR-R01D units in cascade, set ANT
ATT a/b to "0dB" on any DWR-R01D unit that is not
directly connected to the antenna.
30
UTILITY Menu
Item to be set
(BAND)
(ANT ATT a/b)
DC power supply setting for antennas
DC OUT)
Sets the power supply for the antennas connected to the
ANTENNA a/b IN connectors.
This setting applies to both of the ANTENNA IN
connectors.
OFF/9V/12V
Note
When connecting DWR-R01D units in cascade, set ANT
DC OUT to "OFF" on any DWR-R01D unit that is not
directly connected to the antenna.
Items Related to Audio (AUDIO
submenu)
Sync signal setting
(SYNC SOURCE)
Selects the sync signal source for the receiver.
The receiver supports an external sync signal (word clock)
of 32 kHz to 96 kHz.
The synchronization status is indicated by "INT" or
"EXT" in the digital output sync indication on the top
display. When "EXT" is indicated and synchronization is
unlocked, the indication flashes.
INTERNAL: The internal sync signal (48 kHz) is used.
EXTERNAL: Synchronization with an external word
clock signal.
AUTO: The external sync signal is used on a priority
basis. When there is no external sync signal input, the
internal sync signal is used automatically.
Display and adjustment of audio signal
delay times between channels
ADJUST)
During communications between the digital wireless
transmitter and digital wireless receiver, an audio signal
delay will occur as a result of audio signal processing on
both devices.
Display of audio signal delay times
The DWR-R01D unit can display the total audio signal
delay time of the transmitter and the receiver for each
channel using the metadata sent from the transmitter.
Refer to this display when adjusting the delay time using a
device such as mixer or delay processor.
Display example
1CH D : 3.4ms , A : 3.4ms
2CH D : 3.4ms , A : 3.4ms
D: DIGITAL OUT
A: ANALOG OUT
(ANT
(DELAY