Display Of The Transmission Power Setting (Rf Power); Display Of Audio Input Level (Input Level); Display Of The Low-Cut Filter Setting (Lcf); Display Of The +48 V Power Setting (+48V) - Sony DWR-R01D Operating Instructions Manual

Display of the Transmission Power
Setting
(RF POWER)
The transmission power setting of the transmitter from
which transmission is currently being received is
displayed.
Display of Audio Input Level
LEVEL)
The audio input level setting of the transmitter from which
transmission is currently being received is displayed.
Display of the Low-cut Filter Setting
(LCF)
The low-cut filter setting of the transmitter is displayed.
Display of the +48 V Power Setting
(+48V)
The +48 V power setting of the transmitter is displayed.
Display of Accumulated Transmitter
Use Time
(TIME)
The accumulated use time of the transmitter is displayed.
28

RF REMOTE Menu

RF REMOTE Menu
For details on menu operation, see "Basic Menu
Operations" on page 26.
This receiver is equipped with the wireless remote control
function that can be used to set the parameters (low-cut
(INPUT
filter, attenuation operation, power save mode, etc.) of the
transmitter through the TRANSMITTER menu. This
function makes it easier to operate and manage the
microphone system while in the field.
This wireless remote control is 2.4 GHz IEEE802.15.4
compliant and has no effect on the RF band of digital
wireless audio.
This function is activated when pairing is established
between the transmitter and the receiver using the RF
REMOTE menu.
Using the Wireless Remote Control
Function
This function must be set to allow the wireless remote
control function to be used between the transmitter and
receiver.
OFF: Stops the wireless remote control function.
ON: Starts the wireless remote control function with the
previously paired receiver.
Pairing With a Transmitter
Pairing links the receiver with the transmitter which the
wireless remote control function is to be used.
Set pairing configurations as follows:
1
In the RF REMOTE menu, rotate the jog dial to select
PAIRING, and then press the dial.
A message "START PAIRING?" appears.
2
Set the transmitter to be controlled to pairing mode.
For details on how to operate the transmitter, refer to
the operating instructions supplied with the
transmitter.
3
Rotate the jog dial to select YES, and then press the
dial.
The receiver starts searching for transmitters and then
displays the names of transmitters with which pairing
is possible.
During the search, pressing any operation key on the
receiver will cancel pairing mode.
(RF REMOTE)
(PAIRING)