Motion Detection - Kodicom DN-1808S Manual For Installer And User

1.12 Motion Detection

2
1
[Camera]
Select the camera you wish to setup. The
description below is related to the camera you
selected here.
2
[Detection Area]
To enable cameras to record automatically by
motion detection, you mush select the detection
areas. To select detection area, place the mouse
cursor over the channel screen and drag the
cursor in any direction you wish. You can assign
up to 5 separate areas for each camera.
3 [Sensitivity]
Change sensitivity of motion detection. Default
value is set to 15 and it is the recommended value.
Kodicom DN Manual
1
3
4
2
5
1
3
4
5
4a
5a
4
[Alarm]
If the box is checked, the internal speaker will beep
when the camera detects motion.
The speaker however will not beep if the camera is
set to Continuous Recording mode in Scheduled
Setup (see page 26). The speaker's activation time
can set by the scroll lists
5 [Control]
When the camera detects motion, the connected
control will activate for the designated time
Motion Detection
contains the settings for
cameras when motion is
detected. This function is
useful to save hard disk
space from unnecessary
recording.
4a
5a
21