Table of Contents
Advertisement
3.3 Event
3.3 Event
3.3.1 Motion detection
3.3.1 Motion detection
These settings are used to commence recording when motion is detected within a user-defined zone.
You can optimize the recording environment by associating PTZ devices, alarms, and cameras to
motion detection events.
5
6
7
8
Camera : Select camera which you wish to set up.
1
Motion detection grid : Displays the picture for the selected camera. Use the mouse to select and
2
deselect blocks within the area to be used for motion detection. The Green color means area is active
and a blank block means deactivated.
Motion detection area setup : Click left mouse button and drag or select areas for motion detection
area designation.
Motion detection area removal : Click right mouse button and drag or deselect areas to remove
from the motion detection area.
3
Motion setting : This type of recording records motion in the designated areas whenever motion is
occurs.
Block Count : Configure the number of blocks within the motion grid.
Sensitivity : Set up the sensitivity of the motion detection.
Set all area : Select all the motion detection blocks on the grid.
Erase all area : Clear all the motion detection blocks from the grid.
4
Rec time :
Pre rec time : Set the pre recording time for the period between when the motion was
detected and the time when the DVR starts recording.
Post rec time : Set the post recording time for the period after when the motion has stopped
and when the DVR stops recording.
2
56
56
3
4
1
9
Advertisement
Table of Contents
