1.4 Installation Procedure
Follow the steps below to install the DVR:
-Check inventory (see 1.1)
-Place the DVR to proper place following safety precautions in page 2.
-Connect cameras to the DVR (see 1.5 if PAN/TILT cameras are used)
-Connect the DVR to communication network (see 1.6)
-Connect external sensors and controls (see 1.7 and 1.8)
-Plug in the watchdog cable (see 1.9)
IMPORTANT: unconnected watchdog cable is common mistake when
installing Kodicom DVR and causes rebooting every 10 minutes that
may damage the hard disk in the DVR
-Plug in the power cable
9
Kodicom DN Manual