Air Techniques ScanX Classic Instruction Manual page 13

Exit Side Plate Supports Installation (ScanX Classic & ScanX Ortho only)
The supports are used to catch extraoral plates after processing . Refer to Details C and D below and
install the supports as follows .
CAUTION:
1 . Carefully tilt the ScanX back enabling access to the slots under of the ScanX .
2 . Align the two quick connect clips of each support with the corresponding slots .
3 . Insert each support into the slots until a click is heard .
4 . Return the ScanX to the upright position on the installation site counter top .
Note: The power line cord is the
Mains disconnect device.
Line Cord
Detail C
Align Clips
& Slots
Air Techniques, Inc.
ScanX weighs up to 51 pounds. Two people may be required to perform this
installation to prevent damage to the unit.
Power
Supply
ScanX
Side
Detail B
ScanX
Underside
Figure 2 . ScanX Power and Computer Connections
Detail A
Line
Cord
Type B USB
To ScanX
Connector
Inlet
Power
Jack
Type B USB
Receptacle
Inlet Power
Jack
Power and Computer
ScanX
Receptacles Located on Right Rear Panel
Detail D
Snap
Slots
Supports in
Place
Quick
Connect Clips
Classic, Ortho & Intraoral
SYSTEM SETUP
Power Supply
Type A USB
Connector to
Computer
TO
POWER
SUPPLY
Page 13