Load Laminator Overlay Material
Load the overlay material in one laminator cartridge at a time.
The L1 (green) and L2 (orange) cartridges fit only in their assigned locations
inside the laminator. They are not interchangeable.
1.
Open the laminator access door.
2.
Remove the L1 (green) laminator
cartridge from the laminator. Place
the cartridge on a smooth level
surface for loading.
3.
Push the release latch (a) and open
the gate on the laminator cartridge (b).
4.
Remove both used spools from the cartridge (if present).
A-8
SD460 Laminating System