Clean the Laminator
Clean the laminator when at least one laminator cartridge is loaded with
holographic overlay material and any of the following are true:
Particles appear on the laminated cards.
•
Particles are visible inside the laminator.
•
For examples of problems that require laminator cleaning, refer to "Laminator
Problems" on page 50.
This procedure uses a double‐sided, sticky cleaning card that removes holographic
overlay particles from the laminator. When you clean the SD460 system using a
regular cleaning card, the card also moves into the laminator and cleans the
laminator rollers, card entry area, and the impresser exit rollers. This is sufficient if
you are not using holographic overlay. Refer to "Run a Printer Cleaning Card" on
page 30.
1.
Open the laminator access door and
remove the L1 and L2 laminator
cartridges.
2.
Remove printed cards from the
output hopper, if necessary.
A-12
SD460 Laminating System