Load and Replace Supplies
To prepare the printer to print cards, load blank card stock into the input hopper
(optional), and load print ribbon and a cleaning sleeve onto the print cartridge. If
you are using an SD460 system, also load overlay material into the L1 and L2 (if
equipped) laminator cartridges. Refer to Appendix A, "Load Laminator Overlay
Material" on page A‐8, for information about loading the laminator cartridges.
Load Cards
If you are using a manual feed printer, skip this step and keep a supply of blank
cards close to the printer.
For printers with an input hopper, do
the following:
1.
Open the input hopper.
2.
Load the cards into the input
hopper. (Cards can stick together.
Slide or fan the cards to separate
the edges before placing them in
the input hopper.)
•
•
3.
Close the input hopper.
SD Series Card Printers User's Guide
Insert ISO magnetic stripe
cards with the stripe (back
side) facing down and to the
right.
Insert smart cards with the smart card chip facing up and toward the back
of the hopper.
19