Inside The Laminator - DataCard SD Series User Manual

Inside the Laminator

The SD460 system has one standard laminator, in the L1 position, with an
optional second laminator in the L2 position. The laminators apply topcoat or
patch overlay material to the card. Topcoat is a continuous film and patch is a
die‐cut polyester shape. Both laminators can apply either overlay type. Refer to
"Laminator Overlay Materials" on page A‐6.
Manual Advance
Knobs
L1 Laminator
Manual Advance
Knobs
L1 Laminator (green
cartridge)
L2 Laminator (orange
cartridge)
Laminator Access Door
L2 Transport Access
Door
A-4
L2 Laminator
Laminator
Access Door
The manual advance knobs move the card through
the laminator to remove it from the system. Use the
knobs to clear a card jam.
The L1 laminator cartridge holds overlay material and
applies it to the card.
The L2 laminator cartridge holds overlay material and
applies it to the card. The L2 laminator is optional.
The access door provides access to the L1 and L2
laminators to load supplies or to clear a card jam.
The L2 transport access door replaces the L2
laminator cartridge if the optional L2 laminator is not
installed. Open the door to access the laminator
card transport.
L2 Transport
Access Door
SD460 Laminating System