171: Insert Same Card Side 1 Up; 172: Insert Cleaning Card; 173: Improper Shutdown; Laminator Messages - DataCard SD Series User Manual

171: Insert same card side 1 up

1.
Take the card from the printer and turn it over end to end so side 1 is facing
up.
2.
Insert the card in the printer.
3.
If the card is not immediately picked, press the printer's U
click OK.
Click Cancel in the message box if you want to cancel the card.

172: Insert cleaning card

1.
Insert cleaning card.
2.
If the card is not immediately picked, press the printer's U
click OK.
Click Cancel in the message box if you want to cancel the cleaning card.

173: Improper shutdown

Always use the power button to power off the printer.
Click OK in the message box to clear the message.

Laminator Messages

The following messages display on the printer LCD panel when you are using an
SD460 laminating system. They also display in a message box on the PC that
issued the card print job.

177: Laminator not available

The printer and laminator cannot communicate. The card will be canceled.
1.
Make sure the data cable from the laminator to the printer is securely
plugged in.
2.
Press the printer Power button to power off the system.
3.
Press the Power button again to power on the system.

196: Laminator error critical

The laminator has encountered a critical error. The card will be canceled.
1.
Press the printer Power button to power off the system.
2.
Request service. The system must remain powered off.
70
button or
SER
button or
SER
Troubleshooting