4.9.
Setting Installation
After completing the installation that is described in Chapter 6, check the operation and set the details.
In the installation setting, implement the following operations according to the system specification of
the vessel.
1) Changing to a maintenance mode
2) Setting a model
3) Selecting a dimmer unit
4) Setting dimmer control linkage and data sharing
Setting RS-485ID
Setting a dimmer group
Setting data sharing
5) Setting the display screen
6) Setting daisy chain
4.9.1.
Changing to a maintenance mode
Before starting installation, the mode must be changed to a maintenance mode to prevent an operation
error.
Change the mode to a maintenance mode by the initial operation.
Procedure
1.
Display a main menu by pressing
2.
Press
and
3.
The menu is changed to a maintenance menu (maintenance mode).
When the mode is changed to a maintenance mode, the [M] icon is displayed at the bottom of the
screen.
Normal mode
Returning to a normal mode
When
and
mode is reset to a normal mode.
When the power is turned on, the system starts in normal mode.
(normal mode).
for 3 seconds.
Maintenance mode
Figure 4.1 Transition of menu screens
are pressed for 3 seconds or no operation is performed for 3 minutes, the
and
3 seconds
The [M] icon is
displayed.
4-33