Table of Contents
Advertisement
18
CLEANING, CARE
18.1
Cleaning the motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
When cleaning the vehicle with a pressure cleaner, do not point the water jet directly onto electrical components, connectors,
cables, bearings, etc. Maintain a minimum distance of 60 cm between the nozzle of the pressure cleaner and the component.
Excessive pressure can cause malfunctions or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunlight on the motorcycle during cleaning.
–
Close off the exhaust system to prevent water from entering.
–
Remove coarse dirt particles by spraying gently with water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a soft
brush.
Motorcycle cleaner (
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to the dry vehicle; always rinse with water
401061-01
first.
–
After rinsing the motorcycle with a gentle water spray, allow it to dry thoroughly.
–
Empty the carburetor float chamber.
–
Remove the plug from the exhaust system.
Warning
Danger of accidents Reduced braking efficiency due to a wet or dirty brake
system.
–
–
After cleaning, take a short ride until the engine reaches operating temperature.
Info
The heat produced causes water at inaccessible locations in the engine and
brake system to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. (
–
Treat bare metal parts (except for brake discs and exhaust system) with
anti-corrosion materials.
Preserving materials for paints, metal and rubber (
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care prod-
uct.
Special cleaner for glossy and matte paint finishes, metal and plastic surfaces
(
p. 121)
p. 121)
x
Clean or dry a dirty or wet brake system by riding and braking gently.
p. 54)
(
p. 85)
p. 121)
93
Advertisement
Table of Contents
