Table of Contents
Advertisement
15
COOLING SYSTEM
15.8
Refilling with coolant
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of
children.
(125/150 SX)
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Drain plug, water pump cover
B02123-11
(All 250/300 models)
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Drain plug, water pump cover
B02124-11
x
(125/150 SX)
–
Make sure that screw
B02125-10
(All 250/300 models)
–
Make sure that screw
B02126-10
–
Position the motorcycle upright.
–
Fill the radiator completely with coolant.
Coolant
–
Mount radiator cap
–
Run the engine until it is warm.
–
Check the coolant level. (
B02127-10
. Take off radiator cap
with a new seal ring.
M10x1
. Take off radiator cap
with a new seal ring.
M10x1
is tightened.
is tightened.
1.2 l (1.3 qt.)
Coolant (
Coolant (mixed ready to use)
(
.
p. 81)
.
15 Nm
(11.1 lbf ft)
.
15 Nm
(11.1 lbf ft)
p. 119)
p. 119)
82
Advertisement
Table of Contents
