Table of Contents
Advertisement
FRONT FORK - MAGNUM MKII
Install seals in lower sliding tubes.
Install new wear ring on piston, fit damper spring (short) over
piston rod and insert piston assembly in fork tube. Place
damper spring (long) over piston rod and small " 0 " ring on
bolt shaft. Assemble upper and lower fork tubes. Before in-
stalling nut on end of piston rod, place a new fiber washer
over rod end.
Place rubber bellows over tube assemblies and insert tubes
in lower fork bridge.
NOTE: Do not clamp tubes in lower bridge till top bridge
is installed. Place rubber sealing bands (p.n. 321.1.30.859.1)
over upper tube breather holes.
NOTE: These rubber sealing bands prevent the drainage
of oil from fork when moped is layed over on its side.
F7TI
Place both headlamp carriers over upper tubes, ensuring the
rubber guide rings are positioned inside carrier tubes.
T~7~l
- 9 3 -
Hide quick links:
Advertisement
Table of Contents
