Table of Contents
Advertisement
DISMANTLE ENGINE - 2 SPEED
Remove circlip. washer, spring and starter plate from crank-
shaft. Remove clutch adjusting nut. short starting cable and
engaging plate.
Place engine on assembly table 905.0.31.101.2 and unscrew
all housing screws.
Separate housing halves.
Lift crankshaft from lower crankcase half. Remove gasket
and both housing dowels!
NOTE: During engine overhaul it is important to replace
all seals.
.*
Press out drive shaft from left hand housing half and remove
seal. If bearing needs replacement, remove circlip
and
bearing.
- 6 3 -
Hide quick links:
Advertisement
Table of Contents
