Table of Contents
Advertisement
LUBRICATION AND MAINTENANCE
V4ifU2cm)
%in.(2cm
B
Checking the brakes
Front brake
The correct adjusted travel (measured at the end of the
handbrake lever) is "« in. (2 cm). To adjust, loosen the
locknut (1) and turn the adjuster until brake lever travel is
' ^ i n . (2 cm). Tighten the locknut.
Rear Brake
The correct travel (measured at the end oft the handbrake
lever) is V* in. (2 cm). To adjust, loosen the locknut (I) and
turn the adjuster until brake lever travel is
s/
< in. (2 cm).
Tighten the locknut.
Brake linings
Pry plastic inspection plugs from wheel hub. Disconnect
brake cable from brake lever. Insert a feeler gauge between
brake drum a n d brake lining. G a p should not exceed .047 in.
(1,2 cm) at either inspection hole. If gap exceed this measure-
ment, refer to section "BRAKES" on brake replacement.
Do not operate your unit.
FRONT WHEEL REMOVAL
Unscrew speedometer cable from hub. Loosen locknut on
brake cable and remove brake cable from hub. Remove the
axle nuts. Remove wheel from fork.
To replace wheel reverse the above procedure. Torque axle
nuts to 20 ft/lb (27 Nm). Be certain to readjust the brake
before riding.
Hide quick links:
Advertisement
Table of Contents
