Table of Contents
Advertisement
DISMANTLE ENGINE - 2 SPEED
REMOVE ENGINE
Disconnect starter cable on starter lever, then follow the same
procedure to remove the engine as previously outlined. To
remove starter cable lift cover on cable, hold adjusting
sleeve on engine and unscrew cable-end.
/ V
(If engine removed, but not completely dismantled).
> B
Do not turn adjusting sleeve on engine as this would
alter clearance adjustment on starter plate.
i
Drain transmission oil.
NOTE:
M A G N U M MK II, disconnect oil supply line from oil
pump and block-off supply line ta avoid oil drainage from
oil tank.
DISMANTLE ENGINE
Follow the same dismantling procedures as outlined on pre-
vious pages. Remove clutch cover, gasket, locating sleeves,
main shaft and clutch drum shims and roller retainer thrust
plate on main shaft. Inspect bearings inside clutch cover.
To remove bearings, use special puller no. 905.0.14.002.0,
905.0.14.017.0 and 905.0.14.006.0. if not available, heat cover
to appr. 170° F (80" C) and tap cover on workbench.
* .-
- 5 9 -
Hide quick links:
Advertisement
Table of Contents
